Chapter 3. Operating the Display System
STACK ST8130 Series Road Car Display Systems
8
Users Guide
Chapter 3. Operating the Display System
Chapter 3. Operating the Display System
This chapter takes you through the operation of the system so that you
can familiarise yourself with its use before you install it in the vehicle.
Switching the Display System on
Switching the Display System on
You will have switched the system on already if you have followed the
instructions in the previous chapter and have just set the system up for
the first time before installing it.
When installed in the vehicle, the system is switched on when you switch
the ignition on.
When the power is first switched on, the digital display will immediately
show a "Low Oil P" warning and the alarm light will come on. The
tachometer will reset itself by moving the needle until it touches the
stop-pin, and then moving it back to the zero RPM position. Press Switch
3 to clear the warning message from the display. (Switch 2 can also be
used for this.)
The digital display panel and the analogue dial face are always backlit
when the system is switched on.
If none of these actions occurs when you switch on, switch off the power
to the system and consult the section on troubleshooting in this manual.
Changing the display layers
Changing the display layers
The digital display has five display layers. Each display layer shows
three parameters and their values
Each of the display layers is displayed in turn by pressing switch 3. Press
switch 3 when display layer 5 is being displayed in order to return to
display layer 1.
ð
The format of the values in these displays will vary for
systems supplied outside the UK, as the parameters are
displayed in different units.
