STACK ST8130 Series Road Car Display SystemsError! Main Document Only.Chapter 5. Installing the Display System
Users Guide
37
Pressure sensor
Pressure sensor
Fitting the pressure sensor
Fitting the pressure sensor
The Display System is supplied with one of the following types of
pressure sensors: the Stack ST744, the ST745, or the ST746.
The ST744 pressure sensor has an M10 x 1
thread (UK, EU).
The ST745 pressure sensor has a 1/8" NPTF
thread (USA).
The ST746 pressure sensor has a 1/8" BSP
thread.
Each of the above types of sensor is used for
monitoring the oil pressure.
Installing the pressure sensor
Installing the pressure sensor
•
Position the sensor and its cable as far as possible from all sources of
intense heat and from the ignition HT leads.
•
The sensor can be either screwed in directly to the monitoring point or
fitted separately by using a suitable pressure hose to connect it to the
monitoring point. By fitting the sensor separately, you will
reduce the amount of vibration to which it is subjected and
thereby extend its life.
•
Do not over-tighten the sensor.
