STACK ST8130 Road Car Display System
Chapter 2. Getting Started
Users Guide
7
Connecting the Components
Connecting the Components
1. Connect the wiring harness to the display module.
2. Connect the four switches to the cables labelled S1 to S4.
3. Connect each of the sensors that you have purchased to the
appropriate wire in the wiring harness, as shown above.
4. Connect a 12v DC power supply or battery to the power input cable.
Never use a battery charger to supply power to the display module.
5. Switch on the 12v DC power supply.
The Display Module should start up with an alarm signal indicating low
oil pressure.
Note that whenever a warning message is shown on the top line of the
digital display, the speed of the vehicle always continues to be shown in
the centre of the bottom line.
You can now proceed to familiarise yourself with operating the Display
Module.
