STACK ST8130 Series Road Car Display Systems
Chapter 4. Configuring the Display System
Users Guide
27
Note: The petrol (gas) pumps may shut off, if the petrol delivery is
interrupted for a time.
2.
Select the Fuel Tank Sender calibration display.
Hold Switch 1 down and press Switch 2. This gives a display similar
to the following:
Tank Qty 0L
Tank Qty 0L
Reading 255
Reading 255
3.
Use Switches 1 and 2 to change the Tank Qty value to zero if it is not
already zero. Switch 1 decreases the value shown while Switch 2
increases it. Note the Tank Qty and the Reading value in the table
on p30.
When you have set the Tank Qty to the required value, press Switch
3 to set this value.
4.
Press Switch 1 to continue to the next calibration point.
5.
Fill the tank with a small, known amount of fuel, for example, five
litres (one gallon). If the Reading value does not change, there is a
problem with either the fuel sender or the wiring.
6.
Wait for the Reading value to stabilise. This requires several seconds.
While you are waiting for the Reading value to stabilise, use Switch 1
and Switch 2 to change the Tank Qty value to the amount of fuel now
in the tank.
7.
When the Reading value has stabilised, press Switch 3 to set this
value
8.
Repeat steps 6 through 9 above for each calibration until the tank is
full or you have performed at least two or as many as ten calibration
operations.
9.
Press Switch 2 (Finished) when you have completed calibrating the
fuel level readings.
You can press Switch 4 to go to the cancel calibration mode, then Switch
1 to Cancel, or Switch 2 to Continue with calibration.
Cancelling the calibration leaves the original calibration set.
