STACK ST8130 Series Road Car Display SystemsError! Main Document Only.Chapter 5. Installing the Display System
Users Guide
33
Switches
Switches
The four switches are used to control the functions of the Display System.
The normal functions of the four switches are:
Switch
Functions
Switch 1
Show the peak values.
Switch 2
Clear an alarm and show the last alarm.
Switch 3
Change the display layer and clear an alarm.
Switch 4
Reset the trip distance to zero and start the lap timer. The trip
distance is reset after each lap.
Switches 1 & 2
Set up mode.
Switches 1 & 3
Change speed units to MPH or km/h (UK version only).
Switches 1 & 4
Reset the peak values and lap times.
You can install the switches in any convenient location. When installing
the switches, you should take account of the following considerations:
•
The cable for each switch is approximately 400mm/16” in length from
the 19-way military connector.
•
It is important that the driver is able to reach Switch 3 easily in order
to change the display and clear warning messages after alarms. This
switch can be fitted on the steering wheel.
•
When you configure the system, you use Switches 1 to 4 for selecting
the parameters and setting their values. These switches should be
installed so that you can reach them easily when you are viewing the
digital display.
