SST SST-ASI-SLC, User Manual

Page: 62 / 74

SST-ASI-SLC User’s Guide
56
9.5.6 Error Message: “Error during transmission via
AS-i bus”
You can’t change a slave address (except slave zero) while slave zero is
present on the network.
This error might also be caused by bad connections. Verify all connectors and
cables.
9.5.7 Replaced Slave Didn’t Auto Address
For Auto Address Programming to work, you must replace the slave while
the network is powered and running.
1. Remove the slave.
2. Add a new slave of same ID and I/O at address zero.
3. Cycle from Program to Run to clear the fault.
4. The slave is readdressed to replace the failed slave.