User Manual
HART/EtherNet/IP Gateway
GT200-HT-EI
WWW.SSTAUTOMATION.COM
22
As the request is: “None”, the user should fill “0” for the section “Length of Sending Data (BYTE)”
The “Length of Receiving Data (BYTE)” will be 26, which is the sum of 2 status bytes and 24 device response bytes
If the user does not need to map all the variables to the Modbus TCP registers. Please follow the guide below to switch
to the “Advanced Configuration Mode”, then click the “Configuration” button. Only select the variable(s) needed, in
this case, only the “Primary Variable” and the “Secondary Variable” are selected.More details for Advanced
Configuration Mode, please refer to chapter 5.2.2.7.
Notes: Selected variables are listed in the left table. Variables corresponding to the bytes are listed in the table above.
