User Manual
HART/EtherNet/IP Gateway
GT200-HT-EI
WWW.SSTAUTOMATION.COM
18
5.2.2 Configure the HART Fieldbus
5.2.2.1 Set the Parameters of HART Channel
Click the HartChannel0 in the tree view and the configuration section will appear on the right:
HART Master:
Primary master, Secondary master
HART Networks:
Select the networks mode as single or multiple points, under the single point the gateway can
only communicate with the slave device whose address is 0
Retries:
Select the number of retransmission commands, ranging from 0 to 5
Polling:
Determines if the polling function will be used, "Enable" means that the polling function will be enabled.
Delay between polls: S
et the time of the polling command (The time interval from a command to send to start the
next command) with the range of 256 ~ 65535ms
Response timeout: S
et the maximum time that the gateway waits for the slave device to respond, ranging from
256 to 65535 ms
