________________________________________________________________________________________________________________________________________________________________________________________________________________________
70
Product Manual Type:
637f
07-02-10-01-E-V0304.doc
Diagnosis and trouble shooting
7-segment
display
explanation
output
servo drive
display
comment
ready
warning
2)
631
635/637
637+
637f
X 300 – Module not inserted
or wrong inserted or defect
X 300 testing
off off
X 300 – setting wrong
X 30 / X40 Counter-Configuration test in
the EASYRIDER
®
Windows – Software
tracking window exceeded
3)
only in operation mode position control, will be
deleted with the next run-command
tracking error with switch off
only in operation mode "position control"
limit
3)
limit X10.
xx
on 0 Volt,
from
Firmware 6.16
X10.
8
X10.
14
X10.
14
X10.
14
limit switch -
3)
limit switch - X10.
xx
on 0 Volt,
from Firmware 6.16
X10.
9
X10.
15
X10.
15
X10.
15
limit / limit switch -
3)
both limit switch X10.
xx
on 0 Volt,
from Firmware 6.16
X10.
8
X10.
9
X10.
14
X10.
15
X10.
14
X10.
15
X10.
14
X10.
15
memory-checksum-error
try new start, store the value again
off
off
DC Bus Unterspannung < 100 V
-
1: internal software error, Watchdog
2: blinking: BIAS software error
1: Firmware version check
2: Bias program error fix
1)
Reaction to these errors chapter:
Function diagrams from inputs and outputs
2)
With configuration corresponding chapter :
Operating modes and pin functions
3)
Only warning respect. status indicator
The error signals are shown as long as there is control voltage (Us), also when the power (DC-Bus)
is switched off for safety reasons.
