SSANGYONG KYRON 2006, Repair Manual, Page: 800 / 1105

SWITCHES / ELECTRIC DEVICES
KYRON SM - 2005.09
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
106 8510
1. Armed mode activation requirements
1) The “LOCK” output is “ON” when receiving the “LOCK” signal from transmitter while the ignition key is re-
moved and all doors are closed. The armed mode is activated when the door lock switch is locked (theft
deterrent horn output: once, hazard relay output: twice).
2) The theft deterrent horn and hazard relay outputs are “ON” when receiving the “LOCK” signal from the remote
control key again in armed mode (theft deterrent horn output: once, hazard relay output: twice).
3) When receiving “LOCK” signal from the remote control key while any of doors is not closed, only the “LOCK”
output can be done and then activates the armed ready mode (without theft deterrent horn and hazard warning
flasher). At this moment, if the ignition key is in the ignition switch or the door lock switch is unlocked,
cancels the armed mode and activates the normal mode.
However, in these cases, if closing the door, the theft deterrent horn outputs once and the hazard warning
flasher outputs twice and then activates armed mode.
4) When the door is not opened or the ignition key is not inserted into ignition switch for 30 seconds after
receiving “UNLOCK” signal, outputs “LOCK” and then activates armed mode (RELOCK operation). Also, at
this moment, the system outputs the theft deterrent horn and hazard warning flasher.
5) The armed mode will not be activated except above conditions.
Ex) The armed mode will not be activated when the door is locked by the ignition key.
REMOTE CON-
TROL KEY
SIGNAL
ENTRANCE
DOOR SW
ENTRANCE
DOOR LOCK SW
DOOR LOCK
RELAY
(Dr) UNLOCK
RELAY
HAZARD RELAY
HORN
OPERATION
STATUS
LOCK
NO SIGNAL
UNLOCK
OPEN
CLOSE
LOCK
UNLOCK
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ARMED MODE
OTHERS
T1: 0.5 sec T2: 1.0 sec T3: 50 ms T4: 1.0 sec T5: 30 sec
T1
T3
T2
T4
Description of Theft Deterrent Function
T5