SSANGYONG KYRON 2006, Repair Manual, Page: 598 / 1105

RKSTICS (REKES + STICS) / STICS
KYRON SM - 2005.09
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
14
8710
INT Switch Auto Position Reminder (Power-Up Reminder Wiper)
1. When turning off and on the auto INT switch, the system drives the wiper motor through LOW relay regardless of
communication with rain sensor.
2. The wiper relay (LOW) is turned on and the wiper motor runs one cycle when changing the wiper switch to
“AUTO” position from any other positions (while the ignition key is in the “ON” position).
When the wiper switch is turned to the “ON” position again from other positions, the system drives the wiper
motor through LOW relay one cycle only when the rain sensor detects the “Rain Detected” signal.
T1: 1 cycle
T1 T1
T1
Rain sensing unit (auto light integrated type) Multifunction wiper switch: AUTO and sensitiv-
ity control
A sensor that emits infrared rays through LED and then
detects the amount of rain drops by receiving reflected
rays against sensing section (rain sensor mounting sec-
tion on the windshield) with photodiode (auto light sen-
sor integrated type) AUTO: Wiper operates automatically by rain sensor
FAST
↔ ↔
↔ ↔ ↔
SLOW: Auto delay/Auto speed control. A po-
sition that can control sensitivity against rains in the
windshield and transmits wiping demand signal accord-
ingly
KEY IN
& IGN2 SW
ON
OFF
INT AUTO SW
ON
OFF
WIPER
LOW RELAY
ON
OFF
RAIN SENSOR
to RKSTICS
Rain Detected
OFF