SSANGYONG KYRON 2006, Repair Manual, Page: 159 / 1105

CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
MANUAL TRANSMISSION
KYRON SM - 2005.09
35
3170
BRAKE
A / BAG
A/T
M/T
CLUTCH
AXLE
SP
ST’NG
A / CON
T/C
3) Alignment check for clutch housing surface
• Install a dial gauge on the clutch housing surface.
• Note the measurement while rotating the crank-
shaft for one revolution.
Install in the reverse order of removal. Check the compo-
nents for wear or damage before installation.
1. Check the concentric slave cylinder for abnormal wear
and replace if necessary.
2. Check the pressure spring plate for wear.
3. Check the alignment conditions of clutch housing as
follows:
1) Install the magnetic holder on pressure spring.
2) Alignment check for housing bore
• Install a dial gauge in the housing bore.
• Note the measurement while rotating the crank-
shaft for one revolution.
4. Check the following parts, if necessary
1) Pressure plate spring assembly
2) Disc
3) Flywheel
Inspection before Installation
• The excessively worn components should be
replaced.
NOTICE
• If the pointer indicates beyond 0.010 inch, align the
clutch housing by inserting shims between housing
and clutch.
NOTICE
• The excessively worn components should be
replaced.
• SAT clutch cover can not be re-installed if
disassembled. SST is needed for re-vse.
• Refer to the P.11 at the of this book clutch section.
NOTICE