SportsPlay QUICK SHIP UNIT 1 STANDARD, Installation Instructions Manual

Page: 60 / 109

March 13, 2014 8
922-127-3 (3’) DOUBLE WALL STRAIGHT SLIDE
INSTALLATION INSTRUCTION
INSTALLATION INSTRUCTIONS CONTINUED
__9. Insert the 3/8 x 3/8 socket set screws (#10) into the threaded
hole on the bottom side of the four-hole attachment brackets (#4)
and tighten (Detail C on page 7).
__10 . Level and square the slide making sure to keep 11” of
spacing from the slide bed to the top of the safety surfacing.
__11. Once slide is in position and you have verified its square and
level you may
tighten the bolts connecting the slide to the deck.
__12. Inspect the components for sharp edges and if necessary
file them down and apply touch up paint.
__13. Once the entire playground has been installed and you have
verified that the entire playground is level you can
add the
concrete to the footing holes . Be sure to use concrete with a
minimum 2,500 psi and mix the concrete per the manufacturers
directions before you pour it into the footing hole. Once the
footing has been filled with concrete you should rope of the area for
a minimum of 48 hours to allow the concrete set properly.
__14. Once the concrete has set , back fill dirt over the footing
holes; inspect the area and components for tools, hazardous debris
and sharp edges. Verify all components are installed and all
hardware is tight and then install the safety surfacing.
__15. Install labeling as instructed in the appendix of the
instruction manual.