87
Spohn & Burkhardt
DRAFT
7.1.5. Checking friction wheel contact force
Figure 41.
36
36
35
34
33
Friction – adjusting wheel contact force
Regularly check the slewing function of the seat.
If the slewing function of the seat is restricted, adjust the contact force of the friction wheel (33) using
the threaded rod (
34
) as follows:
1. Undo the screws (
36
) for the motor cover (
35
) and remove the motor cover.
2. Adjust the contact force of the friction wheel (
33
) using the threaded rod (
34
).
3. Re-fit the motor cover (
35
) and fasten the motor cover (
35
) using the screws (
36
).
7.2. Components
See the related documentation for information on the servicing of the individual components of the
control stand.
8. Repair
Danger!
All tasks on the device are only allowed to be undertaken by specialist personnel taking
into account the relevant safety regulations. Always pay attention to the safety instruc-
8.1. Control stand
The repair of the control stand by the operating organization is not intended. If repair is necessary, contact
SPOHN & BURKHARDT (for address
8.2. Components
See the related documentation for information on the replacement and repair of the individual compo-
nents of the control stand.
Summary of Contents for FS Series
