Spohn & Burkhardt FS Series, Operating Instructions Manual

Page: 67 / 132

67
Spohn & Burkhardt
DRAFT
Danger!
Make sure that the control stand is secured against tipping and is stored on a suitable
surface to prevent injuries and damage to the control stand.
Danger!
Make sure that all console lids are secured against unintentional opening and the inserts
are firmly fixed to prevent injuries and damage to the control stand.
Note
The control stand is wired to terminals or plugs/sockets according to the requirements of
the operating organization.
The customer's electrical connection is made specifically according to the requirements
of the operating organization and the related circuit diagrams, (see chapter 12. “Reference
documents”, page 90).
Variant with spacer 53035 and 53207
Figure 17.
18
18
17
17
4
4
15
15
15
15
Electrical connection: Variant with spacer 53035 and 53207
1. Disconnect the system from the supply of electrical power.
2. Undo the two securing screws (
18 ) on the spacer ( 4 ).
3. Tip the control stand in the direction of the hinges (
15
), make sure that the control stand is secured
against tipping back and is placed on a suitable surface.
4. Route the cables from below into the spacer ( 4 ) (see Figure 16 “Cable entry”, page 66) .
Attention!
Make sure all cables are laid correctly without kinks or points where they can chafe.
5. Connect the corresponding cables to the terminal block (
20
) (see Figure 16 “Cable entry”, page 66)
as per the related circuit diagrams
(see chapter 12. “Reference documents”, page 90).
6. Undo the lock nut (
21
) on the cable opening (
17
) and remove the corrugated tube (
22
) from the
cable opening ( 17 ) on the spacer, (see Figure 16 “Cable entry”, page 66).
7. Undo the lock nut ( 28 ) on the cable opening ( 27 ) on the consoles and remove the corrugated tube
(
22
) from the cable opening (
27
) on the consoles, (see Figure 16 “Cable entry”, page 66).
8. Guide the corresponding cables through the cable opening (
17
).