Manual for clima BSK4-F / clima BSK4-F230
LON fire damper actuator 4 ports
Order No.: 421 404 / 421 405
status on the nvoDriveStatus. If the protection position is reached by the
end of the phase, the second phase starts. When returning to the normal
position the compliance with the running time specified in SCPTdriveTime
is checked. If the damper does not reach the normal position within the
specified time, an additional half of the running time is waited to see if the
damper still reaches its target. If this is not the case, the maintenance is
aborted due to the error and the causes of the error can be read off as the
damper status on the nvoDriveStatus.
Phase 2
N
N
N
F
F
F
If the normal position has been reached by the end of the phase without
exceeding the runtime (both phases), the maintenance is considered
successfully completed.
Interruption behavior
Depending on which functions are to be implemented with the fire
damper objects, a distinction can be made between different types of
maintenance interruption. In the parameter UCPTbreakMode, you can set
the circumstances under which an active maintenance run is interrupted.
UCPTdrvBreakMode
Interruption behavior
DBM_NUL
Maintenance is not interrupted by operation
commands or maintenance calls.
DBM_ON_FIRE
Maintenance is interrupted by travel
commands in the protective position. In such a
case it is considered as not passed.
DBM_ON_DRIVE
Any run commands during active maintenance
interrupt this. In such a case it is considered as
not passed.
Damper condition
The status of the damper, including maintenance results and runtime check
results, is output on the nvoDriveStatus of the damper object whenever
changes are made. The status can also be read out on the network variable
nvoStatus of the NodeObject when requested by a telegram {x,
RQ_UPDATE_STATUS} via the nviRequest (NodeObject). The damper status is
Version 3.01
Page 32 / 39
01.09.2020
