User’s Manual
40
5. Start PBC pairing procedure at access point side (please refer to the instruction given by
your access point’s manufacturer), then click ‘PBC’ button in wireless configuration utility to
start to establish wireless connection by WPS. Please be patient (This may require several
seconds to one minute to complete). When you see ‘WPS status is connected successfully’
message, means the connection between your wireless network card and access point is
successfully connected by WPS, and the information about access point you connected to
will be displayed.
Sometime WPS may fail, and you can click ‘PBC’ button few more times to try again. When
an access point is connected, you can click ‘Disconnect’ to disconnect your wireless
network card from a connected access point, or select another WPS-enabled wireless
access point, then click ‘Connect’ to establish connection to selected access point, if there
are more than one WPS-enabled access point found. You can also click ‘Rotate’ button,
and next access point on the list will be selected to establish connection.
If you want to delete a found access point from the list, select it and click ‘Delete’ button.
