Spark Fire Ribbon, Installation & Operation Manual

Page: 39 / 48

39
MAXITROL GV60 CONTROL SYSTEM
SETTING PROGRAM TIMERS

You can program two periods of time between
12:00 am and 11:50 pm in each 24-hour cycle.

The Programs P1 and P2 must be set in the fol-
lowing order during a 24-hour cycle: P1 ,
P1 , P2 and P2 .

The icon indicates the beginning of the peri-
od (ON) and the icon indicates the end of the
period (OFF).

If P1 = P1 , P2 = P2 the program-
ming is cancelled.

To keep the fireplace ON all night, set P2 at
11:50 am and P1 at 12:00 am.
Default settings:
Program 1: P1 6:00 am P1 8:00 am
Program 2: P2 11:50 pm P2 11:50 pm

Briefly press SET button to
scroll to TIMER mode.
SETTING P1 ON TIME

Hold the SET button until
P1 (sun) is displayed
and the time flashes.

Press (large flame) button
to set the hour.

Press (small flame) button
to set the minutes.
SETTING P1 OFF TIME

Briefly press SET button o scroll
to TIMER P1 (moon) while
the time flashes.

Press (large flame) button to
set the hour.

Press (small flame) button to
set the minutes.
SETTING P2 ON TIME

Briefly press SET to scroll to TIMER mode
P2 (sun) while the time flashes.

Follow the instructions given to set P1 ON
time.
SETTING P2 OFF TIME

Briefly press SET to scroll to TIMER mode
P2 (moon) while the time flashes.

Follow the instructions given to set P1 OFF
time.
Press OFF button to save these settings. The tim-
ers are programmed. See the diagram on pro-
gramming sequences on the following page.
Tip
If you want to program only one period, program P1
and P1 with desired times and program P2 and
P2 with the same time as P1 .