Spark Fire Ribbon, Installation & Operation Manual

Page: 27 / 48

27
ASSEMBLY & INSTALLATION
Installing or Replacing the Batteries
1. The valve control module is powered by four “ AA ”
batteries. The batteries are mounted within the Valve
Receiver Module located on the right side of the fire-
place attached to a drop-down mounting bracket for
easy accessibility. Refer to the adjacent illustration.
2. Loosen the thumb screw on the module drop-down
mounting bracket by turning counter-clockwise until
the threads are fully disengaged from the base brack-
et.
3. Rotate the Valve Receiver Module and mounting
bracket. Toward you 90 degrees.
4. Slide off the Battery compartment cover.
5. Install the 4 “ AA ” batteries, supplied, using the
guides inside the battery pack to show you the correct
battery orientation.
6. Replace the battery compartment cover. Rotate the
Valve Receiver Module and mounting bracket into
its home position and tighten the thumb screw to se-
cure.
7. The remote handset is powered by three “ AAA ” bat-
teries. The access panel is located on the back of the
handset and simply snaps open to provide access to
the battery compartment. Install the three batteries as
shown on the label inside the remote control battery
compartment.
8. Replace the remote handset access panel.
Placing the Burner Glass Media
The burner glass media poly-bag that you set aside
when you unpacked the fireplace contains the correct
amount of glass material to cover the burner. The en-
tire contents of the bag should be evenly distributed
over the burner tray.
1. Locate the burner in the fireplace. Refer to the
adjacent illustration.
2. Carefully clip one corner of the poly-bag to form a
pouring spout. The opening should be large
enough to allow the glass media to flow but not so
large that you can
’ t control the flow.
3. You will notice that the burner surface is designed
with turned-up edges that form a tray to hold the
glass media.
BURNER TRAY
THUMB
SCREW
ROTATE