![Spark Fire Ribbon Installation & Operation Manual Download Page 28](http://html1.mh-extra.com/html/spark/fire-ribbon/fire-ribbon_installation-and-operation-manual_1339527028.webp)
28
ASSEMBLY & INSTALLATION
4. Starting at one end, pour the glass media onto the
burner tray, keeping the pouring spout on the poly-
bag toward the center of the burner to avoid spillage
of glass pieces over the sides of the burner. See the
adjacent illustrations.
5. Once you have poured all of the glass burner media
into the burner tray, carefully smooth the glass pieces
out so they have a uniform depth over the entire sur-
face of the burner. When the burner glass media is
properly placed, it should look like the adjacent illus-
trations.
6. Note: If a few pieces of glass escape over the edges of
the burner tray during installation, it is not a prob-
lem. They will simply land in the area below the
burner and will do no harm.
Relief Door Installation
1. The top relief doors are shipped separated from the
fireplace and must be installed on the top of the fire-
box at this point in the installation. Note: The relief
doors includes a gasket that covers the full bottom
surface. Use care in handling the relief door to avoid
damage to the gasket material.
2. The first illustration below shows the relief openings
and relief door retainers.
3. Each relief door includes line-up tabs that corre-
spond to slotted retainers on the firebox.
4. Tip the relief door enough to allow the rear line-up tab to engage the rear retainer slot. Refer to the sec-
ond illustration below.
5. Rotate the front edge of each relief door so they line-up over front retainers.
6. Gently spring the front forward so it will allow the relief door front line-up tab to engage on the retain-
er. Refer to the first illustration on the top of page 29.
7. The relief door should be able to move up and down freely on the retainers if properly installed.
8. When the relief door installation is complete, the door should be in the full down position. Refer to the
second illustration on the top of page 29.
BURNER GLASS MEDIA
PARTIALLY INSTALLED
BURNER GLASS MEDIA
FULLY INSTALLED
RELIEF OPENINGS
RETAINERS
RELIEF DOOR FRONT TABS
RELIEF DOOR REAR TAB ENGAGED
IN REAR RETAINERS
Summary of Contents for Fire Ribbon
Page 1: ......
Page 15: ...15 VENT TERMINAL CLEARANCES Venting terminals shall not be recessed into a wall or siding...
Page 33: ...33...