Spark Fire Ribbon, Installation & Operation Manual

Page: 37 / 48

37
MAXITROL GV60 CONTROL SYSTEM

Press and hold (small
flame) button to decrease
flame height or to set the ap-
pliance at pilot flame.

For fine adjustment tap the
(large flame) or (small
flame) buttons.
MODES OF OPERATION
Express Low and High Fire

Double-click (small flame)
button. “ LO ” will be displayed.
NOTE: Flame goes to high fire
first before going to designated
low fire.

Double-click (large flame)
button. Flame automatically
goes to high fire. “ HI ” will be
displayed.
x 2
SETTING °C/24-HOUR OR °F/12-HOUR

In MAN mode, press OFF

and (small flame) buttons
until display changes from
Farenheit/12-hour clock to
Celsius/24-hour clock and
vice versa.
SETTING THE TIME

The time display will flash af-
ter either:
» Installing the battery or
» Simultaneously pressing the
(large flame) and
(small flame) buttons

Press (large flame) button
to set the hour.

Press (small flame) button to
set the minute.

Press OFF or simply wait to return to MAN
mode.

Briefly pressing the SET button
changes the mode of operation in
the following order:
and back to
MAXITROL GV60 CONTROL SYSTEM
NOTE: Manual mode can also be reached by
pressing either the (large flame) or the
(small flame) buttons.

- Manual Mode - Man ual
Flame Height Adjustment.

- Daytime Tempera-
ture Mode (Appliance must be in
standby mode; pilot ignited) - The
room temperature is measured and
compared to the set temperature.
The flame height is then automati-
cally adjusted to achieve the Day-
time Set Temperature.
TEMP

- Nighttime Setback
Temperature Mode (Appliance
must be in standby mode; pilot ig-
nited) - The room temperature is
measured and compared to the
nighttime Setback temperature.
The flame height is then automati-
cally adjusted to achieve the
Nighttime Setback Temperature.

- Timer Mode (Appliance
must be in standby mode; pilot ignited) -
The timers P1 and P2 (Program 1, Pro-
gram 2) each can be programmed to go
ON and OFF at specific times. For in-
structions see Timer Programming Mode.
NOTE: The display shows the set temperature every 30
seconds.