Spark Fire Ribbon, Installation & Operation Manual

Page: 32 / 48

32
1. To turn off gas to the appliance,
push and release the “ OFF ”
button on either the Remote Handset
or on the optional Wall Switch. You
will hear an audible signal confirm-
ing the off setting.
2. TO TURN OFF THE GAS SUPPLY
TO THE APPLIANCE, close the
shut-off valve on the gas supply line
to the appliance.
1. STOP! Read the safety information above on this label.
2. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to light the pilot by hand.
3. Using the Remote Handset, or the optional Wall Switch, push the
“ OFF ” button until you hear an audible signal to insure
the appliance is Off.
4. Wait five (5) minutes to clear out any gas. Then smell for gas including near the floor. If you smell gas, STOP! Follow “ B ”
in the safety information above. If you don ’ t smell gas, proceed to step 5.
5. Using either the Remote Handset, or the optional Wall Switch, simultaneously press the “ ON ” and “ High Flame ” but-
tons. An audible signal confirms the start sequence has begun.
6. Continuing beeps confirm the ignition is in process. Once lighting the pilot flame should appear as shown in Fig.2. Once the
pilot is confirmed, the main burner ignites on high.
NOTE: If the pilot does not stay lit after several tries, proceed to step 9.
7. Use the flame height adjustment buttons on either the Remote Handset or the optional Wall Switch to adjust the flame. Press
the button twice to decrease the flame height to its lowest setting, press the button twice to increase flame height to the
highest setting. Pressing the or button once will module the flame to intermediate settings. The
Remote Handset can also be used to control the appliance thermostatically.
8. Press and hold the button on the Remote Handset or optional Wall Switch to set the appliance to Pilot flame only.
9. If the appliance
will not operate, follow the instructions “ TO TURN OFF GAS TO THE APPLIANCE ” and call your gas
service technician or gas supplier.
LIGHTING AND OPERATION
LIGHTING THE FIRE
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
When lighting this appliance, follow these instructions exactly.
A. This appliance is equipped with an ignition device that automatically lights the pilot. Do not try to light the pilot by hand.
B. BEFORE OPERATIONG THE BURNER SYSTEM, smell around the appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS

Do not try to light the appliance.

Do not touch any electric switch; do not use any telephone in your building.

Immediately call your gas supplier from a neighbor ’ s telephone. Follow the gas supplier ’ s instructions

If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to operate the gas controls. Never use tools. If a knob will not push in or turn by hand, don ’ t try to re-
pair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system which has been under water.
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE
FIG. 2
High Flame
Low Flame
ON/OFF
FIG. 1