88
15
6
9
12
3
15
3
6
12
9
- +
0
FADER
10dB
2
2
1
0
1
5
4
5
4
3
3
BAL
AUX
AUX
4
0
1
2
3
5
6
10
9
8
7
4
0
1
2
3
5
6
10
9
8
7
8
0
2
1
15
15
6
9
12
3
15
3
6
12
9
- +
0
GAIN
20dB
0
5
10
LF
HF
stereo input
FOLIO LITE
has 4 Stereo input channels, suitable for a wide variety of line level sources, such as keyboards, drum
machines, synths or tape machines. The inputs are
balanced
for low noise and immunity from interference, but you can
use
unbalanced
sources (see 'Connections' for wiring details), although you should then keep cable lengths as short as
possible to minimise interference pick-up.
GAIN
This knob allows you to match the
input level to suit a wide variety of
profesional, semi-professional and
hi-fi sources.
Start with a low setting, especially
for professional equipment, and
increase it if you cannot reach an
adequate signal levelwith the fader
at maximum.
EQUALISER
The Equaliser (EQ) gives fine control over the signal quality, to minimise background
noise, or to alter the character of synthesised voices from electronic instruments.
The EQ knobs can have a dramatic effect on the sound, so use them sparingly and listen
carefully to the result.
HF EQ
Turn to the right to boost high (treble)
frequencies by up to 15dB at 12kHz, adding
crispness to percussion from drum machines,
synths and electronic instruments. Turn to the left
to cut these frequencies, reducing hiss or
excessive brillinace. Set the knob in the centre-
detented position when not required.
AUX SEND 1
This is used to set up a separate
mono mix for FOLDBACK or to drive
EFFECTS processors, and the
combination of all the Aux 1 Sends
is mixed to the Aux 1 Output. For
Effects it is useful for this to fade up
and down with the FADER (this is
called POST-FADE), but for
Foldback or Monitor feeds it is
important for the send to be
independent of the FADER (this is
called PRE-FADE). The Master
Section AUX1 PRE switch allows you
to chose pre- or post-fade as
required. Leave the knob turned
down when not in use.
AUX SEND 2
This is similar to the Aux Send
1 control, but is always POST-
FADE.
LF EQ
Turn to the right to boost low (bass)
frequencies by up to 15dB at 60Hz,
adding extra punch to synths,
guitars and drums. Turn to the left to
reduce hum, boominess or improve
a mushy sound. Set the knob to the
centre-detented position when not
required.
BALANCE
This control sets the amount of the
channel signal feeding the Right and
Left MIX outputs, allowing you to
balance the source in the stereo
image. When the control is turned
fully right or left you feed only that
side of the signal to the mix.
FADER
The rotary FADER gives you smooth
control of the overall signal level in the
channel strip, allowing precise balancing
of the various source signals being
mixed to the Master Section.
PFL
When the PFL (Pre-Fade-Listen) switch is
pressed the pre-fade channel signal is
fed in stereo to the Monitor. It may be
heard on headphones or the monitor
output and shown on the meters if the
Master section PFL switch is pressed.
You use this switch to listen to a channel
signal without affecting the mixer
outputs, to check the signal quality, set
the input TRIM, or simply to check that it
is there!
All manuals and user guides at all-guides.com
