Rev. 0
dated 19/06/2001
SVP 0/1/2/3-E - Code: 3529.0091.01
16
Technical Assistance Service
Tel. (+39) 0445.595.111
PT
601
PP
601
GC
601
16-III
3.5
Start up
1) Make sure that the machine voltage shown on the dataplate (see 2.4) cor-
responds to the line voltage available in the place of installation; if it does
not, do not make the electrical hook-up; contact your dealer or the machine
manufacturer immediately.
2) Make sure that the motors rotate in the correct direction; to do this, plug
the machine into the power socket, set the main switch to position 1 (the
warning light ref. 4 Fig. 1 will indicate that the power is on); press the start
button ref. 2 Fig. 1, standing by to press the emergency stop pushbutton
ref. 1 Fig. 1 if necessary. The direction of movement of the top of the
outfeed belt ref. 3 Photo 1 must be outwards from the machine. If it moves
in the opposite direction, press pushbutton ref. 1 Fig. 1; unplug the
machine, open the plug by unscrewing the screws shown in the figure
below and invert the position of the brown and black wires.
If the connection is three phase + n earth there will be two black
wires. In this case either of the black wires can be inverted with the brown
wire. In the case of a three phase + earth cable there is only one black wire
so there is no alternative for the inversion with the brown wire position.
Close the plug with the screws as shown in the above figure and re-insert it
in the power socket. Repeat the steps described at the beginning of this
heading to make sure that the direction of rotation of the motors is correct.
Once you have checked the direction of rotation, switch the machine off.
Caution
Never disconnect or change the position of the yellow/green wire
(earth) and/or the blue wire(s).
Caution
Tampering with/replacing one or more machine components or
assemblies, and/or the use of accessories/attachments or con-suma-
bles that are different from the parts recommended by the Manufac-
turer can result in potential danger of injury to the machine operator
or exposed persons and will auto-matically relieve the Manufacturer
of any what-soever liability for injury to persons and/or damage to
property that may arise.
