Sony VPL-FE100E, Operating Instructions Manual

Page: 32 / 120

32
(GB)
Notes on connections when two or more
switchers are used
• Mount the IFB-12A interface board to the slot 1 of
the number n switcher and connect the output
connector of the number (n+1) switcher to the
IFB-12A.
• You can attach the IFB-12A signal interface board
(when the IN/OUT switch is set to OUT) only to
the number 1 switcher.
To select the projector by designating the
index numbers
When the switchers and projectors are connected as
illustrated, select the desired projector by pressing the
keys on the Remote Commander as shown below.
Number 2 switcher
Device index 01
Group index 01
PC-3000
PC-3000
Projector A
Projector B
PJ COM
PJ COM
PJ COM
PJ COM
Signal flow
Signal flow
Signal flow
Number 1 switcher
Device index 02
Setting the Index Numbers
Example:
To select all the projectors
GROUP
n
ALL
n
ENTER
n
ALL
n
ENTER
Projectors A, B, C and D are selected.
To select projectors with device index 01 from all the
groups
GROUP
n
ALL
n
ENTER
n
1
n
ENTER
Projectors A and C are selected.
To select a projector with device index 01 from group
index 02
GROUP
n 2 n ENTER n 1 n ENTER
Projector C is selected.
To select all the projectors from group index 02
GROUP
n
2
n
ENTER
n
ALL
n
ENTER
Projectors C and D are selected.
Notes
• Set the group index and device index numbers
correctly. If more than two projectors are set to the
same group index and device index numbers, an error
message will be displayed when the SYS SET key is
pressed.
• If the group index is a tens digit number, press the
GROUP key before each press of the number key.
Example:
To select a projector with device index 13 of group
index 12
GROUP
n
1
n
GROUP
n
2
n
ENTER
n
1
n
3
n
ENTER
Group index 02
PC-3000
PC-3000
Projector C
Projector D
PJ COM
PJ COM
PJ COM
Signal flow
Signal flow
Signal flow
Number 2 switcher
Device index 01
Number 1 switcher
Device index 02