Sony UWP-V1, Service Manual

Page: 12 / 164

1-8
UWP Series
Lever
Installation
1. After removing the front cover, hold the tuner unit by
the top and bottom, then insert the tuner unit into the
slot.
2. Match the six latches with the six holes on the front
panel, then replace the front cover.
3. Tighten the screws on the front cover to secure it to the
front panel of the MB-X6.
When using the MB-806A
Removal
1. On the bottom panel of the MB-806A, locate the lever
corresponding to the slot of the URX-M2 to be
removed and pull the lever forward. The URX-M2 is
ejected from the slot.
Installation
The MB-806A Tuner Base Unit can accommodate up to 6
URX-M2.
1. Inspect the top and bottom side of the URX-M2.
2. Holding both sides of the URX-M2, insert it into the
slot. Push it in until you hear a click.