Sony RMT-V256A, Service Manual

Page: 60 / 84

6-3
2-3. SERVO SYSTEM CHECK
2-3-1. RF Switching Position Adjustment
(MA-339 Board)
[Adjustment Purpose]
To adjust the link of the A-ch and B-ch of the tape playback outputs.
To make the unit compatible with other tapes and units. If this
specification is not satisfied, the link will appear on the screen and
the screen will be disrupted, etc.
Mode Playback
Signal Alignment tape: SP color bar portion
Measurement point CH1: CN262 pin
1
(PB RF)
CH2: CN262 pin
2
(RF SWP)
Measuring instrument Oscilloscope
Adjusting element Remote commander CH+/–
Specified value A=minimize
[Adjustment Method]
1)
Playback the alignment tape.
2) Short CN262 pin
5
to Ground.
3) Check that “A P” is indicated on FL display.
4) Adjust so that part A becomes minimized at CH +/–.
5) Write data in EEPROM by pressing PAUSE button.
6) The display changes to “A H” and the mode goes to the HiFi
switching position Adjustment.
Fig. 6-2-3
2-4. AUDIO SYSTEM ADJUSTMENT
• Adjust both L ch and R ch.
[Connecting Instruments]
Fig. 6-2-4
2-4-1. Hi-Fi Audio System Adjustment
• Perform the adjustment setting the switch on the following
positions.
• AUDIO MONITOR ..................................................... STEREO
[Adjustment Method]
1.
ACE head adjustment.....Refer to the VHS mechanical
adjustment manual (S MECHANISM)(9-921-647-11).
2. E-E output level check
3. “Recording Bias Adjustment”
A
CH1
PB RF
CH2
RF SWP
CN500
3
A (L) OUT
4
A GND
Audio line INPUT L/R
Audio oscillator
Attenuator
600
Ω
Audio level meter
or distortion meter
47 k
Ω
VTR