– 2 –
MAIN BOARD IC8005 (Flash)
z
z
MAIN BOARD IC5405 (NV-RAM)
z
VF BOARD IC4502 (D/A CONV.(EVR))
z
LCD BOARD IC4301 (D/A CONV.(EVR))
z
Mecha. Deck Block
z
Touch Panel
z
*1
LCD Block LCD4301 (LCD Panel)
z
z
EVF Block LCD4701 (LCD Panel)
z
• Adjustment items required at the replacement of main parts and boards
Adjust the items marked with
z
in the following table when main parts were replaced.
7. ADJUSTMENTS
For the adjustment of this set, the test mode and the firmware data writing are provided.
In the test mode, various adjustment, setting, and checking can be made. Also, the firmware data writing is executed when the Main board
itself, or the Flash Memory (IC8005) or MPEG Control (IC8501) on the Main board is replaced.
TABLE OF CONTENTS
7-1.
Test Mode ...................................................................... 3
1-1. Outline of Test Mode ..................................................... 3
1-2. EVF System Adjustment ............................................... 5
1-3. LCD System Adjustment ............................................... 8
1-4. Servo System Adjustment ............................................. 13
1-5. MAC Address Setting .................................................... 16
1-6. Touch Panel Adjustment ............................................... 20
1-7. Other Checking ............................................................. 21
7-2.
Firmware Data Writing Method ..................................... 23
2-1. Preparation .................................................................... 23
2-2. Writing to Flash Memory (IC8005) ................................ 26
2-3. Writing to MPEG Control (IC8501) ............................... 26
Replacement parts
Adjustment items
Table.7-1
*1
Note:
When LCD panel in the LCD block was replaced, first perform the LCD system adjustment, and then the touch panel position
alignment.
EVF System
Adjustment
LCD System
Adjustment
Servo System
Adjustment
MAC Address
Setting
Touch Panel
Position
Alignment
Summary of Contents for MDDISCAM DCM-M1
