Sony LMT-300, Service Manual

Page: 43 / 92

2-15 (E)
LMT-300
Procedure
1. Acquire a backup package from the DigitalCinema home page.
2. After backup operation, turn off the power and then turn on it.
3. Copy the three
fi les in “Required equipment” to any folder in PC.
4. In the MS-DOS command line of PC, move to the directory, in which the three fi les copied in proce-
dure 3 are stored, using a cd command.
n
Check that the “setupdata” fi le acquired in Section 2-3-1 exists in the same folder.
5. Enter “putsetup.bat 192.168.1.10”.
(“192.168.1.10” is the IP address of this unit.)
6. Data begins to be automatically sent from PC to this unit. An intermediate fi le is created inside this
unit.
7. Connect this unit to a network using an IE browser.
8. Install
a putsetup.elp fi le in this unit using an IE browser.
The intermediate fi le in this unit is automatically written into the memory area of this unit.
(Refer to Section 2-2 for details of installation.)
9. Perform the time setting of SMS server.
n
When the PU-131 board assembly is replaced, the time of SMS server may be delayed long. The time
is able to check at the upper-right of the PJT screen.
(1) Connect the USB keyboard to the blank USB connector on the rear of this unit.
(2) Reboot this unit.
(3) Press the F2 key at starting to enter the BIOS setting screen.
(4) Set the date and time correctly.
n
Be sure to set the time using UTC.
(5) Press the F10 key to save the setting and exit the BIOS setting screen.
The SMS server is rebooted.
10. Check the setting on the Menu-Maintenance-Network Setup screen of PJT.
n
The network setting returns default because of the rebuild of the network setting. Perform the network
setting of CTRL IN terminal as needed.
11. Check the setting on the Menu-Content-S2S Network Setup screen of PJT, then change the setting as
needed.
c:\>cd temp
c:\temp>
c:\temp>putsetup 192.168.1.10