Sony LMT-300, Service Manual

Page: 32 / 92

2-4 (E)
LMT-300
Event
classi
fi cation
Event display Description Remedy
0000 INFORMATION SHOW START
FAILED
VERIFY:<Verify
Status> <cplid> The CPL veri fi cation status of <cplid> failed in
the start of projection because it is <Verify
Status>.
Operation state information
SHOW START
FAILED
VALIDATE:<Validate
Status> <cplid> The CPL validity veri fi cation status failed in the
start of projection because it is <Validate
Status>.
KDM KEY TYPE
MISSING:<kdmid> KeyType in KDM of <kdmid> did not exist.
SHOW START
FAILED MISMATCH
CONTENT AUTH
<cplid> The start of projection failed because CPL
ContentAuthenticator of <cplid> does not
coincide.
SHOW START
FAILED MISMATCH
KEY TYPE <cplid> The start of projection failed because CPL Key-
Type of <cplid> does not coincide with Key-
Type speci
fi ed by KDM.
SHOW START
FAILED.
TDL ERROR MB
<cplid> The start of projection failed because the
certi
fi cate information of MediaBlock is not
described in TDL of KDM for CPL of <cplid>.
SHOW START
FAILED.
TDL ERROR PRJ
<cplid> The start of projection failed because the
certi
fi cate information of projector is not
described in TDL of KDM for CPL of <cplid>.
KDM ALL DELETED All KDMs are deleted.
SHOW START
FAILED.
SUBTITLE UNWRAP
FAILURE. <cplid> The start of projection failed because the
unwrapping of CPL caption
fi le of <cplid> has
failed.
CC UNWRAP
FAILURE. <cplid> The unwrapping of closed caption fi le failed.
Mismatch HI/VI
channel label HI/VI channel con fi guration labels are different
in reels
S2S CLIENT
TRANSFER START Transfer of S2S client was started.
S2S CLIENT
TRANSFER END Transfer of S2S client was ended.
DCP TRANSFER
START Transfer of S2S server was started.
DCP TRANSFER
END Transfer of S2S server was ended.
DCBLOCK Version
mismatch DCBLOCK version mismatch
0004 ERROR MPU BOOT ERR An error occurs during MPU start. Replace the PU-131 board.
0006 ERROR MPU DDR ERR An error occurs in the memory of MPU. Replace the DDR SDRAM
DIMM module of a PU-131
board assembly.
0007 ERROR PU LOW VLT The decrease in the supply voltage of the
PU-131 board is detected. Check that a detection
switching regulator is not
defective.
0008 WARNING BTRRY DFCT The voltage decrease in a spare battery for
commercial AC power stop is detected. Replace the four backup
batteries of two fan units.
0011 ERROR PU SRAM ERR An error occurs in SRAM on the PU-131 board. Replace the PU-131 board.
0028 WARNING THERMO ERR An error occurs in the temperature sensor on
the PU-131 board. Replace the PU-131 board.