Sony Ipels PCS-G50, Service Manual

Page: 59 / 200

PCS-G50/G50P
4-25
4-2. Operation Check in Diag Mode
This unit can perform an individual operation check in
Diag mode other than the self-diagnosis mode.
The operation check in the Diag mode is not required
under normal operation because it can be executed by the
operation using GUI or the Web control function when the
application software is in active state.
Command in the Terminal Software
In this Section, the command (written in bold) input from
the terminal PC and the response status are as follows.
(Example)
command> led 1
↓
:
Enter “
led 1
” from the terminal PC, and press the
Enter key.
ON LED: connection status:
Response status for entering “
led 1
”.
4-2-1. LED Light on Check
1. Refer to Section 4-1-2, and start the Diag mode.
2. Check that all the LED’s on the front panel of the unit
are lit.
ON LINE:
blue
POWER: orange
LAN ALERT: orange
3. Enter the following command from the terminal PC,
and check the response status.
command> led 1
↓
ON LED: connection status
4. Check that the LED on the front panel of the unit is lit
as bellow.
ON LINE: blue
POWER: dark
LAN ALERT: dark
5. Enter the following command from the terminal PC,
and check the response status.
command> led 2
↓
ON LED: LAN
ON LINE
POWER
LAN ALERT
LOGO
6. Check that the LED on the front panel of the unit is lit
as bellow.
ON LINE: dark
POWER: dark
LAN ALERT: orange
7. Enter the following command from the terminal PC,
and check the response status.
command> led 3
↓
ON LED: power red
8. Check that the LED on the front panel of the unit is lit
as bellow.
ON LINE:
dark
POWER: red
LAN ALERT: dark
9. Enter the following command from the terminal PC,
and check the response status.
command> led 4
↓
ON LED: power green
10. Check that the LED on the front panel of the unit is lit
as bellow.
ON LINE: dark
POWER: green
LAN ALERT: dark
11. Enter the following command from the terminal PC,
and check the response status.
command> led 5
↓
ON LED: LOGO
12. Check that the LOGO LED on the unit’s top plate is
lit.
13. Enter the following command from the terminal PC,
and check that all the LEDs are lit.
command> led all
↓
14. Enter the following command from the terminal PC,
and check that all the LEDs are lit.
command> led off
↓