6-103
HVR-A1J/A1U/A1N/A1E/A1P/A1C
3-31.
Cam Gear Ass’y, Mode Gear Ass’y
1.
Removal procedure
1)
Remove the screw (special head screw M1.4
×
1.4)
1
.
2)
Remove the dowel from the cam base ass’y
2
. Slide the cam
base ass’y
2
, and remove the pin
C
, and remove the cam
base ass’y
2
.
3)
Remove the mode gear ass’y
3
.
2.
Attachment procedure
1)
Apply grease equally on the sliding surface of the FP-032
flexible board and the mode gear ass’y.
2)
Install the mode gear ass’y
3
.
3)
Install the cam base ass’y
2
while engaging it in the pin
C
and the dowel.
4)
Install the screw (special head screw M1.4
×
1.4)
1
.
Tightening torque: 0.06
±
0.01 N•m (0.61
±
0.1 kgf•cm))
5)
Apply grease on the specified locations of the mode gear ass’y.
Amount of grease: A ball of grease of 0.5 mm diameter.
1
Screw
(M1.4
×
1.4)
2
Cam base ass'y
Mode gear shaft
Apply grease when installing
Amount of grease: A ball of
grease of 0.5 mm diameter.
Apply grease equally when installing.
Apply grease on the
sliding surface of the
FP-032 flexible board
with the mode gear
ass'y.
FP-032 flexible board
• Be careful so that the dust should not be
adhered to the greased surface.
• After cleaning, grease is applied.
3
Mode gear ass'y
Mode gear ass'y
Come gear ass'y
Dowel
Apply grease
Apply grease
Mode gear ass'y
Apply grease
Points to be noted
Points to be noted
Key Points
in Re-assembling
Alignment mark
