6-18
DSR-570WS/570WSP V1
6-14. Replacement of LD Motor
Assembly
The components of the LD motor assembly include
the worm shaft assembly. This Section explains the
LD motor assembly and worm shaft assembly.
Removal
1. Disconnect the connector (CN517) of the LD
motor assembly shown in the figure.
2. Remove the two screws, and remove the LD
motor assembly.
3. Remove the worm shaft assembly from the
motor holder.
4. Attach the new worm shaft assembly to the
motor holder so that the gears engage as shown
in the figure.
5. Apply grease onto the worm shaft assembly.
Attachment
6. Attach the new LD motor assembly to the two
protrusions shown in the figure, and secure with
the two screws.
n
After attaching, check to see that the worm shaft
assembly and No. 1 gear are engaged as shown in
the figure.
If not, move No.1 gear up and dowm so that they are
engaged correctly.
7. Insert the connector (CN517) of the LD motor
assembly into the HN-227 board.
LD motor assembly
Worm shaft
assembly
Screw
Motor holder
Protrusion
Screw
Protrusion
CN517
No. 1 gear
Worm shaft assembly
Motor holder
LD motor gear
Apply grease.
Worm shaft gear
Summary of Contents for DSR-570WS
