4-12
CCU-TX7 (E)/V1
4-2-19. WIDE ID Level Adjustment
[For the Serial No. 10601 and Higher (UC)]
[For the Serial No. 40251 and Higher (CE)]
Note :
Before starting this adjustment, complete the
adjustments as instructed in section 4-2-7, 4-2-8 and
4-2-17.
Equipment
:
Waveform monitor
To be extended :
ES-20 board
Preparation :
.
Select the BARS mode on the RCP-TX7/TX7P or COU-
TX7.
S1/DU-33 board (on the ES-20 board)
→
ON
.
Select the 16:9 mode. (How to select the 16:9 mode differs
depending on the equipment connected to the unit.)
[When the RCP-TX7/TX7P is connected]
n
For details, refer to the RCP-TX7/TX7P operating instruction.
1. Select the advanced setting mode.
2. Press the menu selector button “OTHERS” nine times.
3. Select 16:9 with the setting button.
[When the COU-TX7 is connected]
n
For details, refer to the DXC-D30WS/D30WSP operating
instruction.
Switch 16:9/4:3 to the 16:9 setting mode using the advanced
menu page 9 of the DXC-D30WS/D30WSP.
Adjustment point :
1
RV1/DU-33 board (on the ES-20
board)
A
1H
[For NTSC]
[For PAL]
A
1H
OFF
CN1
S1
RV1
ON
DU-33 Board
(A SIDE)
Adjustment Procedure :
1. Select the lines on the waveform monitor.
20 lines [NTSC]
23 lines [PAL]
2. Test point
: VBS 1 OUT connector/CCU rear panel
Specification : A = 70
±
5 IRE [For NTSC]
A = 500
±
10 mV [For PAL]
