1-17
CCU-TX7 (E)/V1
16
5
Push the board fully in, and refasten the board retainer,
using the two screws removed in step
2
.
6
Set the SDI POWER switch to ON. (See page 13.)
7
Power on the CCU-TX7/TX7P, and carry out auto level
adjustment. (See page 17.)
8
Close the front panel of the CCU-TX7/TX7P, and fasten
the screws.
Board retainer
Fitting and Adjustment
17
Auto Level Adjustment
The auto level adjustment is necessary to ensure that the video
levels are appropriate. Carry out auto level adjustment in step
6
(page 16) of the procedure under “Fitting and Adjustment”.
1
Power on the CCU-TX7/TX7P, CA-TX7/TX7P, and
camera.
2
On the RCP-TX7 or COU-TX7/TX7P select “BARS”.
Color bars appear in the monitor or viewfinder.
3
With a pen or other sharp implement, press the AUTO
LEVEL switch.
After a few seconds, when the AUTO LEVEL indicator
lights in green the auto level adjustment is completed.
Notes
• If the indicator lights in red, check the switch setting on the
board. (See step
1
on page 14.) If the indicator flashes, check
that color bars are being displayed.
• The adjustment values are stored on this board, so
readjustment is not normally required.
However, if the CCU-TX7/TX7P is not used for a long time
(several months), or if the board is installed in a different
CCU-TX7/TX7P, the auto level adjustment must be made
again.
For details of the operating procedures for other devices, refer to the
operating instructions supplied with each device.
