52
5-15
5-14
F1
ALU 2P
ALU 3P
Operation
5.6
Easy Alu
function
The
Easy Alu
function automatically recognises the
Alu required by the operator and the rim dimension
parameters, once the gauge has been positioned on
the rim.
The machine presents only the possible Alus in relation
to the contact points selected by the operator.
Note
:
Alu 4 and Alu5 are not included in the
Easy Alu
function. They require manual setting by the
operator.
At this point you can change the Alu mode suggested
by the machine, using the “
Easy Alu Toggle
” function
,
by using the Menu key
F1
(
Fig. 5-14
).
5.6.1 Automatic rim dimension reading
and setting and Alu Mode
Preparations:
—
Compensation run carried out, if necessary (
F
6.1).
—
Wheel correctly clamped (
F
5.1).
—
Select the Vehicle type (
F
5.5.1).
—
Enter rim width (
F
5.5.2).
Important:
For machines without SONAR,
The width of the rim must always be acquired by the
keyboard.
The OK indication and recommendation for optimisation,
as well as the optimisation procedure itself, will only be
accurate if the rim width has been correctly entered.
Automatic rim distance and diameter reading with
an internal gauge arm
—
Move the internal gauge arm gauge into position
on the rim to select the initial weight application
position (internal rim side). Keep it in this position
until an audible signal is heard.
For Alu2P and Alu3P
(
Fig. 5-15
):
—
Position and hold the internal gauge in the second
position on the rim to select the application position
on the right side of the rim.
Shortly afterwards the machine emits an audible signal
to indicate that the machine automatically saves the
weight application coordinates.
—
Move the gauge to the idle position.
—
For Alu2P and Alu3P you can proceed with a
measuring run (
F
5.7.1).
