![background image](http://html.mh-extra.com/html/smc-networks/rb5701-z/rb5701-z_user-manual_1300610067.webp)
Appendix A: Using the Key Pad
Page 62 | August 17, 2010
Mounting the Key Pad
To mount a key pad to the wall:
1.
Use a Phillips screwdriver to remove the faceplate from the front
of the key pad (Figure 6).
Behind the circuit board, four holes are visible at the back of the device.
Figure 6
2.
Place the key pad on the wall where you want it located, and use a pen to mark the location of
the four holes.
3.
Install four screws in the locations marked on the wall. Do not screw them in all the way.
4.
Affix the key pad to the installed screws.
5.
Replace the faceplate to the front of the key pad.
Changing the Batteries in the Key Pad
To replace the batteries in the key pad:
1.
With a Phillips screwdriver, remove the screw from the battery cover in
the back of the key pad and remove the cover.
2.
Find the two supplied CR2 3-volt lithium batteries and install them
positive end up.
3.
Replace the battery cover.