SMC Networks CE2, User Manual

Page: 40 / 53

３７
Press either READ or WRITE to proceed to the input
condition for cylinder stroke setting. The first decimal
point will start to blink.
Use LEFT and RIGHT buttons to select digit to be
changed and set the digit to the desired setting through
UP and DOWN buttons. With that, input desired cylinder
stroke.
After setting of cylinder stroke, press WRITE to switch
to the next input condition. The display will indicate
PRG STEP P2 and the current tolerance setting. At the
same time, the first decimal point will start blinking.
Next, enter the desired tolerance value as in above
mentioned method.
The maximum possible input value is 9.9mm.
<Reference>
With input of tolerance, 1.0, any point fall between the
set point
±
1.0 will be accepted. If the attempt falls
outside the range, retries will perform to get into the
required range.
If the required position is not achieved within the
maximum retries, positioning error (Err9) will be shown.
After setting of tolerance range, press WRITE to switch
to the next input condition. The display will indicate
PRG STEP P3 and the current maximum retries.
Next, enter desired maximum retries.
The maximum possible input value is 9.
ＰＲＧ ＳＴＥＰ Ｐ１
″
″
″
〟
１０００．０
Blinking
ＰＲＧ ＳＴＥＰ Ｐ２
″
″
″
〟
１．０
Blinking
ＰＲＧ ＳＴＥＰ Ｐ３
″
″
″
〟
９
Blinking
Setting Point
Tolerance
－１．０ ＋１．０
１０００．０
２
１
９
８
UP
DOWN
RIGHT
LEFT