SMC Networks CE2, User Manual

Page: 43 / 53

４０
9-2 Program Setting
Input desired cylinder positions.
9-2-1 Input Method
Turn the controller switching mode to PROGRAM.
Note:
Step 0 for every program is END.
Program no.
“1” will start blinking.
Set the program no. through UP & DOWN buttons.
Program No.
, 1 , 2 ,
・・・・・・・・・・・
, 15 , 16
After above setting, press WRITE to end the
operation. Step
“0” starts to blink.
Next, press either READ or WRITE to proceed to
next stage.
The display
“End” will be replaced by “0000.0”,
leading to the input STEP 1.
Input first setting position into STEP 1.
Then, press WRITE to proceed to STEP 2.
Set the following setting positions.
STEP by STEP.
After inputting the last data into last STEP, press
WRITE, and then END to end the program setting.
Note:
Controller will show Err7 during operation, if END is
not inputted at the end of program.
With above mentioned inputting steps,
input program shown below: -
ＰＲＧ １ ＳＴＥＰ ０
Ｅｎｄ
″
″
″
〟
Blinking
ＰＲＧ １ ＳＴＥＰ １
″
″
″
〟
００００．０
Blinking
ＰＲＧ １ ＳＴＥＰ ２
″
″
″
〟
００００．０
Blinking
ＰＲＧ １ ＳＴＥＰ ０
Ｅｎｄ
″
″
″
〟
点滅
UP DOWN