Slant/Fin VHG-100-CH, Installation And Service Manual

Page: 143 / 164

E93.1901EN032 Installation and Service Manual SlantFin VGH-CH / CO
143
•
Engage the high temp braided rope and
place it in contact with the glue and
press the braids.
•
Reinstall electrodes
R
EPLACEMENT OF THE BURNER DOOR INSULATION
.
The insulation burner door is fitted to the burner diameter and is maintained by 2 glue silicone dots. If the insulation
is damaged and needs to be changed, it has to be replaced by a new insulation using the method described below.
1. Remove the electrodes by unscrewing the 4 fixing screws.
2. Remove the defective/damaged insulation sliding under the periphery of the insulation a thin tool (for
example, a ruler) to loosen the insulation and remove it without damaging the glass braid that is glued.
2.1 Remove and clean the rests of the insulation and glue silicone.
2.2 Put 2 dots of glue silicone, temperature-resistant (loctite 5366 or Ottoseal S17), according to the location
below indicated
2.3 Make sure that the burner is in proper condition, remove any possible insulation residues on the burne
2.4 Engage the insulation and place it in contact with the 2 dots of glue silicone
Figure 18.10
Figure 18.11
Figure 18.12 Figure 18.13