IDP 800 Terminal Series - Hardware Guide
T209, Version 01 80 © SkyWave Proprietary
2.
Use a wire stripper to remove 4 mm of insulation from the wires (Figure 61).
Figure 61 Recommended Stripping Length
3.
Twist the ends tightly to prevent stranded wires from fraying.
CAUTION
Do not
solder dip.
4.
Slide the following items over the cable in sequence and as shown in Figure 62: a
sealing nut and a back shell.
Figure 62 Cable with Sealing Nut and a Back Shell
5.
Push the red O-ring inside the back side of the back shell (Figure 63).
Figure 63 O-ring
6.
Verify the red gasket is present and oriented with the flat face visible in the front
side of the back shell as shown in Figure 64.
Back Shell
Sealing
Nut
4 mm
12 mm
max.
Summary of Contents for IDP 800 Series
Page 102: ...www SkyWave com ...