SkyWave IDP 800 Series, Hardware Manual, Page: 68 / 102

IDP 800 Terminal Series - Hardware Guide
T209, Version 01 56 © SkyWave Proprietary
CAUTION Prior to working on any cabling, ensure
that the terminal is powered off and
will not start while work is in progress.

Do not route the cable near the engine if routing through the engine compartment.
This location will subject the cable to extreme heat.

Keep the cable away from hot surfaces such as exhaust pipes as this may damage the
cable.

Do not run the cable over sharp or jagged edges.

Place the cable in recesses and channels, whenever possible, to prevent potential
damage or wear by foot traffic.
Note: Remember to leave enough cable slack near the terminal for strain relief so as
not to introduce any additional force on the connector. SkyWave recommends
securing the cables during installation.
Figure 44 Sample Cable Placement in a Vehicle Cab
Run the cable assembly following the steps below.
1. Use tape to temporarily secure the terminal in its final location while you run the
cable.
CAUTION Do not drill any
mounting
holes at this time.
2. Search for vehicle cab entry points on the side of the vehicle closest to the fuse
panel. This helps to minimize the amount of cable routed along the floor of the
cab.
Where possible route the cable through existing holes in the floor or the firewall
of the engine compartment.
3. Route the cable starting from the terminal to the fuse panel or battery source.
Note: SkyWave recommends that you tape cable ends to prevent dirt from collecting
on the contacts.