SkyAzúl Greer MG514, Installation, Calibration, And Service Manual

Page: 42 / 90

39
2.6.10 Menu 09 - Head Angle
This menu is used to enter data on boom head angles.
1. Measure the boom head angle on a new jib installation to ensure the jib radius displays
correctly. Take this measurement in increments similar as used on the boom moments.
2. Take these measurements from the boom head after the boom angle has been zeroed and
spanned. Set the angle of the boom to “0” on the display and the boom extended in increments.
Do not change the angle of the boom during this process.
3. Use a digital level on the top of the boom head section to enter the angle readings into the
calibration.
4. Press the 09 Head Angle button to enter the head angle readings from the boom extensions.
5. With the boom fully retracted, take a reading from the digital level. Press the Edit button to cycle
the display through two options:
a. Enter New Extension - If no entry is needed, press the Exit button and advance to the
next setting.
b. Enter New Head Angle - Enter the new head in degrees and tenths, using the number
entry procedure from the front of the manual.
6. Follow this procedure for the remaining boom extensions.
TEST
SET
SkyAzúl, Equipment Solutions www.skyazul.com 301-371-6126