SkyAzúl Greer MG514, Installation, Calibration, And Service Manual

Page: 26 / 90

23
2.6.3 Menu 02 - Dimensions
Use this menu to enter the previously recorded physical dimensions of the crane.
1. Press the Next or Prev button until “02 Dimensions” appears in the right of the information
window.
2. Press the 02 Dimensions button to enter the routine.
3. Press the Swing Offset X.X button.
4. Enter the value for the swing offset. The only time this measurement will be positive, is if the
boom pivot pin is in front of the center of rotation.
5. Use the buttons adjacent to the numerical values at the bottom of the window to scroll left or
right and highlight each number.
6. Use the Swing Offset button to enter the number. When complete, the menu will automatically
change to enter the next value.
7. To skip to the next value, press the Exit button.
NOTE: Enter numbers in feet and tenths (XX.XX). Enter negative values when appropriate.
8. Enter the remaining values. After each value is entered, the menu will automatically change to
enter the next value. When all values have been entered, the main menu will be displayed.
TEST
SET
TEST
SET
SkyAzúl, Equipment Solutions www.skyazul.com 301-371-6126