59
SKOPE VF Series
Replacement Procedures
Service Manual
Hinge Reversal
The door can be hinged on either the left or right hand side. When reversing
the hinging, order and fit the opposite top hinge, door switch holder, and
bottom hinge. Refer to the table below for top hinge and door switch holder
part numbers.
Door hinge bracket and top plate part numbers
To reverse the door hinging
Item
LH door
RH door
Top hinge
V65FV/389
V65FV/388
Door switch holder
V65FV/390R
V65FV/390L
Bottom hinge
V65FV/394
V65FV/393
1. Disconnect the cabinet from the mains power supply.
2. Remove the door (see “Removal and Refitting” on page 58).
3. Remove torsion bar assembly from the door (see “Torsion Bar Replacement”
on page 57) and the top door bush.
4. Detach the gasket from the hinge side of the door to access the black plastic
gasket retainer, and use a flat blade screwdriver to remove the hinge side
gasket retainer from the door frame.
5. Reverse door heater element flex so that it exits the door frame at the
opposite end.
6. Refit the hinge side gasket retainer and reattach the gasket.
7. Refit the torsion bar assembly into the opposite end of the door.
8. Refit top door bush.
9. Remove the sign panel (“Sign Assembly” on page 53)
10. Remove the control panel from the cabinet (located abvove the doors).
11. Detach the door switch.
12. Swap the top hinge, door switch and bottom hinge with the opposite parts.
Note:
The opposite parts are not supplied with the cabinet and must be
ordered.
13. Relocate door switch to opposite side of door opening (new non-hinge side)
and reattach wires.
14. Refit the door to the cabinet (see “Removal and Refitting” on page 58).
15. Re-tension the door (see “Tension Adjustment” on page 57).
