53
SKOPE VF Series
Replacement Procedures
Service Manual
7
Replacement Procedures
Sign Assembly
The chiller is fitted with either a sign replacement panel (not lit) or a lit sign,
which can be removed for transporting or moving through doorways or
confined spaces. Refer to the procedures below to remove and refit the sign
assembly. For sign lighting information, refer to “Lighting” on page 54.
Note:
The cabinet should be disconnected from the power supply when
removing lit sign assemblies.
To remove the sign replacement panel or lit sign panel assembly
To refit the sign replacement panel or lit sign assembly
1.
Lit sign panel only.
Unplug the ENSTO sign supply flex from the unit junction
box, located behind the sign panel.
2. Loosen and rotate the sign retaining clips on top of the sign sides.
3. Lift the sign panel up and off
the cabinet.
1. Slot the tabs on the back of the sign panel onto the end of the sign sides.
2.
Lit sign panel only.
Plug the ENSTO sign supply flex into the sign socket on the
side of the unit junction box, located behind the sign panel.
