9
SKOPE ReFlex Chef Base Fridge
Electronic Controller
Service Manual
Controller Faceplate
Buttons and
Display
The controller faceplate includes the front display panel and interface
buttons.
Service Mode
Service mode can be accessed and used via the SCS Connect Field app
(see “SCS Connect Field App and Track App” on page 11), or the controller
faceplate (
refer to Wellington Drive Technologies documentation for further
information
).
Note:
A 9 digit pin code is required to access service mode via the controller
buttons. Contact SKOPE to receive your service mode pin code.
1
2
3
4
5
8
7
11
10
9
6
No. Description
1
Night Mode:
Indicator. On during night mode.
2
Display:
Indicator. Digital display of cabinet air temperature or messages.
The temperature is what the sensor inside the cabinet detects, and not
necessarily the product temperature. However, they may be very close
depending on how the controller is set to sense temperature.
3
Light Switch - Night Mode (back/abort):
Button. Press to switch the lights
on or off. Press and hold to switch cabinet between day and night mode. Used
during programming.
4
Up:
Button. Used for programming.
5
Bluetooth:
Indicator. On when ready to connect to a device. Flashing when
connected to a device.
6
Defrost Cycle (next/enter):
Button. Press and hold to initiate manual defrost.
Used during programming.
7
Down:
Button. Used for programming.
8
Fault - Alarm:
Indicator.
On during fault or alarm. Note: Alarm message is
also shown on the display during alarm.
9
Compressor:
Indicator. On when the compressor is running.
10
Defrost Mode:
Indicator. On during defrost cycle.
11
Fan:
Indicator. On when evaporator fan running.
