34
Replacement Procedures
Service Manual
SKOPE ReFlex Chef Base Fridge
Condenser
Fan
The condenser fan assembly is made up of a fan motor, fan blade and
mounting brackets which can be replaced if necessary.
If the fan stops for any reason, check all connections to ensure no plugs
have come loose.
It is important that the fan blade and/or fan motor is replaced with the same
part to ensure safety, correct alignment, refrigeration performance, and
compliance. Fan blades should be tightened to the recommended torque
settings (shown in the table below).
Fan motor manufacturer recommended torque settings
To access and remove the condenser fan assembly
IMPORTANT
Replace the motor with the same SKOPE OEM part.
DO NOT
use alternative parts.
Fan motor manufacturer Torque setting
Wellington Drive
1.4 Nm
1. Disconnect the cabinet from the power supply, remove the unit cover and
remove the LH panel
(see “Unit End Panel” on page 29).
2. Remove the unit centre pillar (Unscrew 2 screws on the top and 2 screws on
the bottom)
3. Take note of cable routing (photo recommended), then cut the cable ties
holding the condenser fan motor cable along the cartridge, and free up the
condenser fan motor cable.
4. Unscrew the condenser fan assembly from the condenser coil, and remove
the assembly (fan motor, fan blade, mounting brackets) from the cartridge by
lifting the shroud up and out.
