MAINTENANCE PROCEDURES
Track
Track Condition
WARNING
Remove the tether cord cap and
key before performing any main-
tenance or adjustment, unless oth-
erwise specified. Vehicle must be
parked in a safe place, away from
the trail.
Remove the tether cord cap and key.
Lift the rear of the snowmobile and
support it with a wide-base snowmo-
bile mechanical stand with a rear de-
flector panel. With the engine off, ro-
tate the track by hand, and inspect con-
dition. If worn or cut, or if track fibers
are exposed, or if missing or defective
inserts or guides are noted; contact an
authorized Ski-Doo dealer.
Snowmobiles Equipped with
Traction Enhancing Products
If your snowmobile is equipped with
a BRP approved studded track, refer
to
INSPECTION
in the
TRACTION EN-
HANCING PRODUCTS
subsection.
WARNING
Riding with a damaged track or
studs could lead to a loss of con-
trol.
Track Tension and Alignment
NOTE:
Track tension and alignment
are interrelated. Do not adjust one
without the other.
WARNING
To prevent serious injury to indi-
viduals near the snowmobile:
– NEVER stand behind or near a
moving track.
– Always use a wide-base snow-
mobile stand with a rear deflec-
tor panel if it is necessary to ro-
tate track.
– When the track is raised off the
ground, only run it at the lowest
possible speed.
Centrifugal force could cause de-
bris, damaged or loose studs,
pieces of torn track, or an en-
tire severed track to be violently
thrown backwards out of the tun-
nel with tremendous force.
Track Tension Verification
NOTE:
Ride the snowmobile in snow
about 15 to 20 minutes prior to adjust-
ing track tension.
1. Remove tether cord cap and key.
2. Lift rear of vehicle and support it off
the ground.
CAUTION Use proper lifting
techniques, notably using your legs
force. Do not attempt to lift the rear
of vehicle if it is above your limits.
3. Allow rear suspension to fully ex-
tend.
4. Set tool O-ring to specification .
TRACK ADJUSTMENT SPECIFICATION
Tundra
Sport
30 mm - 35 mm
(1-3/16 in - 1-3/8 in)
Track
deflection
setting
Tundra LT
Tundra
Extreme
40 mm to 45 mm
(1-1/2 in to 1-9/16 in)
Track
load
reading
7.3 kg (16 lb)
96
______________
Summary of Contents for Tundra Series
