Ski-Doo Tundra Series, Operator'S Manual

Page: 43 / 159

CONTROLS, INSTRUMENTS AND EQUIPMENT
mmo2008-008-012_b
TYPICAL
1. Brake lever
2. To apply brake
4) Parking Brake Lever
Parking brake lever is located on the LH
side of handlebar.
Parking brake should be used when-
ever snowmobile is parked.
mmo2008-008-012_c
TYPICAL
1. Parking brake lever
WARNING
Make sure parking brake is fully
disengaged before operating the
snowmobile. When you ride the
vehicle, brake pads that are caused
to drag by a continuous pressure
on the lever may cause damage to
the brake system and cause loss of
braking capacity and/or fire.
To Engage Parking Brake
Apply and hold brake, then lock brake
lever using the parking brake lever as
shown.
mmo2009-005-006_a
TYPICAL — ENGAGE MECHANISM
Step 1: Apply and hold brake
Step 2: Lock brake lever using parking brake
lever
To Release Parking Brake
Squeeze brake lever. Parking brake
lever will automatically return to its
original position.
Always release parking brake before
riding.
WARNING
Make sure parking brake is re-
leased before operating the ve-
hicle. If parking brake is left ON
while riding, it may cause damage
to the brake system and cause loss
of braking capacity and/or fire.
5) Engine Cut-Off Switch
The engine cut-off switch (tether cord)
is located to on the LH side of console.
The tether cord cap must be securely
snapped on the engine cut-off switch
to allow vehicle operation.
Pulling the tether cord cap from the
switch shuts the engine off.
_______________
41